公司主要经营:电子产品,日用品,汽车配件,玩具,各种塑料件加工产品/服务。 服务热线:15336531380
1)精度小于0.05的孔普铣做不了,需要CNC加工;如果是通孔也可以线切割。
2)淬火后的精孔(通孔)需要线切割加工;盲孔需要淬火前粗加工,淬火后精加工。非精孔在淬火前做到位就可(留淬火余量单边0.2)。
3)宽度2MM以下的槽需要线切割加工,3-4MM槽深度很深也需要线切割加工。
4)淬火件粗加工最少留余量0.4,非淬火件粗加工留余量0.2。
5)镀层厚度一般是0.005—0.008,加工时要按镀前尺寸。
1) Hole milling with an accuracy of less than 0.05 cannot be done, and CNC machining is required; if it is a through hole, wire cutting can also be performed.
2) Fine holes (through holes) after quenching need wire cutting; blind holes need rough machining before quenching, and fine machining after quenching. Non-fine holes can be made in place before quenching (leave the quenching margin on one side 0.2).
3) Slots with a width of less than 2MM require wire cutting, and deep 3-4MM slots also require wire cutting.
4) The minimum allowance for roughing of hardened parts is 0.4, and the allowance for roughing of non-hardened parts is 0.2.
5) The thickness of the coating is generally 0.005—0.008, and the size before plating should be used during processing.